Pni Legacy Comm Board Bedienungsanleitung PDF herunterladen (Seite 30)

PNI Corporation 133 Aviation Blvd., Suite 101, Santa Rosa, CA 95403-1084 USA;, Fax: (707) 566-2261

For the most current specifications, please visit our website at: www.pnicorp.com

Page 30 of 42

SPI Hardware Handshaking Line Descriptions

SYNC

SYNC is usually low. SYNC must be toggled from low-high-low. This is the SPI reset. This line is used to reset

the SPI slave when communications get out of synchronization. SYNC is normally used during the module

startup.

DRDY – Data Ready

The module returns DRDY. DRDY is low after a SYNC. Once a command has been received and the data is read,

DRDY goes high. This is only used with modules that do not have processor.

NOTE:

See the applicable PNI module data sheet for specific information on communication and control using

the SPI interface

CommBoard

SPI Interface to Sensor Module

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Keine Kommentare

Pni Legacy Comm Board Bedienungsanleitung Seite 30